ASTM D4633 PDF

Designation: D − 10Standard Test Method for Energy Measurement for This test method is under the jurisdiction of ASTM Committee D18 on Soil and. Purchase your copy of ASTM D – 16 as a PDF download or hard copy directly from the official BSI Shop. All BSI British Standards available. ASTM D ,. “Standard. Test Method for Stress Wave. Energy Measurement for Dynamic. Penetrometer. Testing. Systems”. [2], speclfles.

Author: Meztilar Doule
Country: Guadeloupe
Language: English (Spanish)
Genre: Life
Published (Last): 7 November 2013
Pages: 300
PDF File Size: 17.60 Mb
ePub File Size: 7.45 Mb
ISBN: 557-5-68913-649-7
Downloads: 83415
Price: Free* [*Free Regsitration Required]
Uploader: Zulum

The Standard Penetration Test is the most common type.

It is not intended for use with down-hole hammers. What is a standard? See also Refs 1- 6.

It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. In this system, the pound lbf represents a unit of force weightwhile the unit for mass is slugs.

Alternatively, the N-value can be used directly in foundation design using correlations to design parameters such as allowable bearing pressure ast pile capacity.

Report error on page. In this system, the pound lbf represents a unit of force weightwhile the unit for mass is slugs. Reporting of test results in units other than SI shall not be regarded as nonconformance with this test method.

  MANUAL DE RELATII INTERNATIONALE ANDREI MIROIU PDF

Users of this standard are cautioned that compliance with Practice D does not in itself assure reliable results.

ASTM D – 16 – Standard Test Method for Energy Measurement for Dynamic Penetrometers

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. This procedure may also be applicable to other dynamic penetrometer tests.

It is beyond the scope of this standard to consider significant digits used in analytical methods for engineering design. Your shopping cart is empty. Read more about SIS Subscriptions. Since the measured energy includes the extra potential energy effect due to the set per blow, tests for energy evaluation of the hammer systems should be limited to moderate N-value ranges between 10 and 50 Ref 7.

Reporting of test results in units other than SI shall not be regarded as nonconformance with this test method. Soil and Rock I: The inch-pound units given in parentheses are mathematical conversions which are provided for information purposes only and are not considered standard. General terms and conditions Cookies och Javascript Disclaimer Contact. Shopping cart Close cart 0, foreach: Historical Version s – view previous versions of standard.

It is not intended for use with down-hole hammers. When you use our service you can be assured the latest editions and easy access.

  BIOLOGIA LA VIDA EN LA TIERRA TERESA AUDESIRK DESCARGAR PDF

Standard Test Method for Energy Measurement for Dynamic Penetrometers

Ast procedure may also be applicable to other dynamic penetrometer tests. Valid Buy this standard. The quality of the result asstm by this standard is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. The N-value depends on the soil properties but also on the mass, geometry, stroke, anvil, and operating efficiency of the hammer. Contact us svenska Login.

Reliable results depend on many factors: Message to your colleague. The standard is now in your shopping cart.

ASTM D4633 – 16

Link to Active This link will always route to the current Active version of the standard. This energy measurement procedure can evaluate variations of N-value resulting from differences in the hammer system. Sustainable Development Goals and standardisation, how do they connect?

Subscribe on standards – Read more. Please note that the selected standard is invalid. These d6433 and footnotes excluding those in tables and figures shall not be considered as requirements of the standard.